Examinando por Materia "Fenton"
Mostrando 1 - 7 de 7
Resultados por página
Opciones de ordenación
Ítem Degradación de Colorante Amarillo 12 de Aguas Residuales Industriales utilizando Hierro Cero Valente, Peróxido de Hidrógeno y Radiación Ultravioleta(Centro de Informacion Tecnologica, 2016-01-01) Gilpavas, E.; Medina, J.; Dobrosz-Gómez, I.; Gómez, M.Á.; Gilpavas, E.; Medina, J.; Dobrosz-Gómez, I.; Gómez, M.Á.; Universidad EAFIT. Departamento de Ingeniería de Procesos; Procesos Ambientales (GIPAB)The Fenton heterogeneous process in a fluidized bed reactor using Zero Valent Iron (ZVI), in the metallic state, for the treatment of textile wastewater has been used an analyzed. The aim of this work was to optimize the following operating parameters: initial dye concentration, H2O2 concentration, pH, amount of ZVI, and UV radiation, for the removal of dye and organic matter. At first, a fractional factorial experimental design allows defining the most influential factors. After that, they were optimized using the Response Surface Methodology coupled to the Box-Behnken experimental design. The optimal conditions were found to be as follows: initial dye concentration, 881 mg/L; pH 5; ZVI concentration, 5,31 g/L; H2O2 concentration, 0,86 mL/L. At these conditions, the degradation kinetics was performed, reaching 100% and 80,83% of dye and chemical oxygen demand respectively, in 150 minutes of reaction.Ítem Degradation of Yellow 12 Dye in Industrial Wastewater using Zero-Valent Iron, Hydrogen Peroxide and Ultraviolet Radiation(Centro de Informacion Tecnologica, 2016-09-17) GIL PAVAS EDISON; Medina, J.; Dobrosz-Gómez, I.; Gómez, Miguel Angel; Universidad EAFIT. Departamento de Ingeniería de Procesos; Desarrollo y Diseño de ProcesosThe Fenton heterogeneous process in a fluidized bed reactor using Zero Valent Iron (ZVI), in the metallic state, for the treatment of textile wastewater has been used an analyzed. The aim of this work was to optimize the following...Ítem Degradation of Yellow 12 Dye in Industrial Wastewater using Zero-Valent Iron, Hydrogen Peroxide and Ultraviolet Radiation(Centro de Informacion Tecnologica, 2016-09-17) GIL PAVAS EDISON; Medina, J.; Dobrosz-Gómez, I.; Gómez, Miguel Angel; GIL PAVAS EDISON; Medina, J.; Dobrosz-Gómez, I.; Gómez, Miguel Angel; Universidad EAFIT. Departamento de Ingeniería de Procesos; Procesos Ambientales (GIPAB)The Fenton heterogeneous process in a fluidized bed reactor using Zero Valent Iron (ZVI), in the metallic state, for the treatment of textile wastewater has been used an analyzed. The aim of this work was to optimize the following...Ítem ¡En la U estamos recuperando aguas residuales!(2020-12-01) Martinez Guerrero, Christian Alexander; Christian Alexander Martinez-Guerrero; Christian Alexander Martinez-Guerrero; GilPavas, Edison; Drobosz-Gomez, Izabela; Gómez-García, Miguel-Ángel; Procesos AmbientalesÍtem Optimization and toxicity assessment of a combined electrocoagulation, H2O2/Fe2+/UV and activated carbon adsorption for textile wastewater treatment(Elsevier, 2019-02-15) GilPavas, E; Dobrosz-Gomez, I; Gomez-Garcia, MA; GilPavas, E; Dobrosz-Gomez, I; Gomez-Garcia, MA; Universidad EAFIT. Departamento de Ingeniería de Procesos; Procesos Ambientales (GIPAB)In this study, the potential application of sequential Electrocoagulation + Fenton (F) or Photo-Fenton (PF) + Active carbon adsorption (EC + F/PF + AC) processes were analyzed as alternatives for the treatment of an industrial textile wastewater resulting from an industrial facility located in Medellín (Colombia). In order to maximize the organic matter degradation, each step of the treatment was optimized using the Response Surface Methodology. At first, the optimal performance of EC was achieved with Fe electrodes operating at pH = 7, jEC = 10 mA/cm2 and 60 rpm, during 10 min of electrolysis. At these conditions, EC let to remove 94% of the dye's color, 56% of the COD and 54% of the TOC. Next, sequentially applied Fenton or photo-Fenton process (i.e., EC + F/PF), operating at the optimized conditions (pH = 4.3, [Fe2+] = 1.1 mM, [H2O2] = 9.7 mM, stirring velocity = 100 rpm and reaction time = 60 min.), improved the quality of the treated effluent. The EC + F let to achieve total color reduction, as well as COD and TOC removals of 72 and 75%, respectively. The EC + PF reached 100% of color, 76% of COD and 78% of TOC reductions. The EC + F/PF processes were more efficient than EC in elimination of low molecular weight (<5 kDa) compounds from wastewater. Moreover, the BOD5/COD ratio increased from 0.21 to 0.42 and from 0.21 to 0.46 using EC + F and EC + PF processes, respectively. However, EC + F/PF were not fully effective for the removal of acute toxicity to Artemia salina: 20% and 60% of reduction in toxicity using EC + F and EC + PF, respectively, comparing to very toxic (100%) raw textile wastewater. Thus, activated carbon adsorption was applied as an additional step to complete the treatment. After AC adsorption, the acute toxicity decreased to 10% and 0% using EC + F and EC + PF, respectively. The total operational costs, including chemical reagents, electrodes, energy consumption and sludge disposal, were of 1.65 USD/m3 and 2.3 USD/m3 for EC + F and EC + PF, respectively. © 2018 Elsevier B.V.Ítem Optimization and toxicity assessment of a combined electrocoagulation, H2O2/Fe2+/UV and activated carbon adsorption for textile wastewater treatment(Elsevier, 2019-02-15) GilPavas, E; Dobrosz-Gomez, I; Gomez-Garcia, MA; Universidad EAFIT. Departamento de Ingeniería de Procesos; Desarrollo y Diseño de ProcesosIn this study, the potential application of sequential Electrocoagulation + Fenton (F) or Photo-Fenton (PF) + Active carbon adsorption (EC + F/PF + AC) processes were analyzed as alternatives for the treatment of an industrial textile wastewater resulting from an industrial facility located in Medellín (Colombia). In order to maximize the organic matter degradation, each step of the treatment was optimized using the Response Surface Methodology. At first, the optimal performance of EC was achieved with Fe electrodes operating at pH = 7, jEC = 10 mA/cm2 and 60 rpm, during 10 min of electrolysis. At these conditions, EC let to remove 94% of the dye's color, 56% of the COD and 54% of the TOC. Next, sequentially applied Fenton or photo-Fenton process (i.e., EC + F/PF), operating at the optimized conditions (pH = 4.3, [Fe2+] = 1.1 mM, [H2O2] = 9.7 mM, stirring velocity = 100 rpm and reaction time = 60 min.), improved the quality of the treated effluent. The EC + F let to achieve total color reduction, as well as COD and TOC removals of 72 and 75%, respectively. The EC + PF reached 100% of color, 76% of COD and 78% of TOC reductions. The EC + F/PF processes were more efficient than EC in elimination of low molecular weight (<5 kDa) compounds from wastewater. Moreover, the BOD5/COD ratio increased from 0.21 to 0.42 and from 0.21 to 0.46 using EC + F and EC + PF processes, respectively. However, EC + F/PF were not fully effective for the removal of acute toxicity to Artemia salina: 20% and 60% of reduction in toxicity using EC + F and EC + PF, respectively, comparing to very toxic (100%) raw textile wastewater. Thus, activated carbon adsorption was applied as an additional step to complete the treatment. After AC adsorption, the acute toxicity decreased to 10% and 0% using EC + F and EC + PF, respectively. The total operational costs, including chemical reagents, electrodes, energy consumption and sludge disposal, were of 1.65 USD/m3 and 2.3 USD/m3 for EC + F and EC + PF, respectively. © 2018 Elsevier B.V.Ítem ¿Sabías que en la U se están recuperando aguas residuales?(2020-12-01) Martinez Guerrero, Christian Alexander; Christian Alexander Martinez-Guerrero; GilPavas, Edison; Drobosz-Gomez, Izabela; Gómez-García, Miguel-Ángel; Vicerrectoría de Descubrimiento y Creación